C613-50631-01 Rev A Command Reference for IE340 Series 2177
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
802.1X COMMANDS
DEBUG
DOT1X
debug dot1x
Overview Use this command to enable 802.1X IEEE Port-Based Network Access Control
troubleshooting functions.
Use the no variant of this command to disable this function.
Syntax
debug dot1x [all|auth-web|event|nsm|packet|timer]
no debug all dot1x
no debug dot1x [all|auth-web|event|nsm|packet|timer]
Mode Privileged Exec and Global Configuration
Usage notes This command turns on a mode where trace-level information is output during
authentication conversations. Be aware that this is a very verbose output. It is
mostly useful to capture this as part of escalating an issue to ATI support.
Examples Use this command without any parameters to turn on normal 802.1X debug
information.
awplus# debug dot1x
awplus# show debugging dot1x
Related
commands
show debugging dot1x
undebug dot1x
Command
changes
Version 5.4.9-2.1: command added to AR2050V, AR3050S, and AR4050S
Parameter Description
all Used with the no variant of this command exclusively; turns off all
debugging for 802.1X.
auth-web Specifies debugging for 802.1X auth-web information.
events Specifies debugging for 802.1X events.
nsm Specifies debugging for NSM messages.
packet Specifies debugging for 802.1X packets.
timer Specifies debugging for 802.1X timers.
802.1X debugging status:ď€
802.1X events debugging isď€
802.1X timer debugging is onď€
802.1X packets debugging is onď€
802.1X NSM debugging is onď€
To Next Page
Loading...
Need help?
General
