Allied Telesis IE340 Series - passive-interface (RIP)

C613-50631-01 Rev A Command Reference for IE340 Series 1055
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
RIP COMMANDS
PASSIVE
-INTERFACE (RIP)
passive-interface (RIP)
Overview Use this command to block RIP broadcasts on the interface.
Use the no variant of this command to disable this function.
Syntax
passive-interface <interface>
no passive-interface <interface>
Default Disabled
Mode RIP Router Configuration
Example Use the following commands to block RIP broadcasts on vlan2:
awplus# configure terminal
awplus(config)# router rip
awplus(config-router)# passive-interface vlan2
Related
commands
show ip rip
Parameter Description
<interface> Specifies the interface name.