C613-50631-01 Rev A Command Reference for IE340 Series 284
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
SYSTEM CONFIGURATION AND MONITORING COMMANDS
NO
DEBUG ALL
no debug all
Overview This command disables the debugging facility for all features on your device. This
stops the device from generating any diagnostic debugging messages.
You can optionally disable the debugging facility for only the given protocol or
feature. The features available depend on your device and will be a subset of the
features listed in the Syntax section below.
Syntax
no debug all [bgp|ipv6 ospf|ipv6 rip|dot1x|nsm|ospf|pim
dense-mode|pim sparse-mode|rip|vrrp]
Default Disabled
Mode Global Configuration and Privileged Exec
Example To disable debugging for all features, use the command:
awplus# no debug all
To disable all BGP debugging, use the command:
awplus# no debug all bgp
To disable all 802.1X debugging, use the command:
awplus# no debug all dot1x
Parameter Description
bgp Turns off all debugging for BGP (Border Gateway Protocol).
dot1x Turns off all debugging for IEEE 802.1X port-based network
access- control.
ipv6 ospf Turns off all debugging for IPv6 OSPF (Open Shortest Path
First).
ipv6 rip Turns off all debugging for IPv6 RIP (Routing Information
Protocol).
nsm Turns off all debugging for the NSM (Network Services
Module).
ospf Turns off all debugging for OSPF (Open Shortest Path First).
pim dense-mode Turns off all debugging for PIM (Protocol Independent
Multicast) Dense Mode.
pim sparse-mode Turns off all debugging for PIM (Protocol Independent
Multicast) Sparse Mode.
rip Turns off all debugging for RIP (Routing Information Protocol).
vrrp Turns off all debugging for VRRP (Virtual Router Redundancy
Protocol).
To Next Page
Loading...
Need help?
General
