Allied Telesis IE340 Series - router-id

C613-50631-01 Rev A Command Reference for IE340 Series 1172
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
OSPF COMMANDS
ROUTER
-ID
router-id
Overview Use this command to specify a router ID for the OSPF process.
Use the no variant of this command to force OSPF to use the previous OSPF
router-id behavior.
Syntax
router-id <ip-address>
no router-id
Mode Router Configuration
Usage Configure each router with a unique router-id. In an OSPF router process that has
active neighbors, a new router-id is used at the next reload or when you restart
OSPF manually.
Example The following example shows a fixed router ID 10.10.10.60
awplus# configure terminal
awplus(config)# router ospf 100
awplus(config-router)# router-id 10.10.10.60
Related
commands
show ip ospf
Parameter Description
<ip-address> Specifies the router ID in IPv4 address format.