Allied Telesis IE340 Series User Manual

C613-50631-01 Rev A Command Reference for IE340 Series 799
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
LINK AGGREGATION COMMANDS
SHOW
ETHERCHANNEL
show etherchannel
Overview Use this command to display information about an LACP channel specified by the
channel group number.
The command output also shows the thrash limiting status. If thrash limiting is
detected and the action parameter of the thrash-limiting command is set to
vlan-disable, the output will also show the VLANs on which thrashing is detected.
For information on filtering and saving command output, see the “Getting Started
with AlliedWare Plus” Feature Overview and Configuration Guide, which is
available on our website at alliedtelesis.com.
Syntax
show etherchannel [<1-248>]
Mode User Exec and Privileged Exec
Example
awplus# show etherchannel
Output Figure 19-3: Example output from show etherchannel
Example
awplus# show etherchannel 1
Output Figure 19-4: Example output from show etherchannel for a particular channel
Parameter Description
<1-248> Channel-group number.
awplus#show etherchannel 
LAG Maximum : 128
LAG Static Count : 0
LAG Dynamic Count : 1
LAG Total Count : 1
Lacp Aggregator: po1
Member:
port1.0.1
port1.0.2
awplus#show etherchannel 1
Aggregator po1 (4601)
Mac address: 00:00:00:00:00:00
Admin Key: 0001 - Oper Key 0000
Receive link count: 0 - Transmit link count: 0
Individual: 0 - Ready: 0
Partner LAG: 0x0000,00-00-00-00-00-00
Link: port1.0.1 (5001) disabled
Link: port1.0.2 (5002) disabled

Allied Telesis IE340 Series Specifications

General

Brand	Allied Telesis
Model	IE340 Series
Category	Switch
Language	English