Allied Telesis IE340 Series User Manual

C613-50631-01 Rev A Command Reference for IE340 Series 2443
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
RADIUS COMMANDS
RADIUS
-SERVER RETRANSMIT
radius-server retransmit
Overview This command sets the retransmit counter to use RADIUS authentication on the
device. This command specifies how many times the device transmits each
RADIUS request to the RADIUS server before giving up.
This command configures the retransmit parameter for RADIUS servers globally.
If the retransmit parameter is not specified for a RADIUS server by the
radius-server host command then the global configuration set by this command
is used for the server instead.
Use the no variant of this command to reset the re-transmit counter to the default
(3).
Syntax
radius-server retransmit <retries>
no radius-server retransmit
Default The default RADIUS retransmit count on the device is 3.
Mode Global Configuration
Examples To set the RADIUS retransmit count to 1, use the following commands:
awplus# configure terminal
awplus(config)# radius-server retransmit 1
To set the RADIUS retransmit count to the default (3), use the following
commands:
awplus# configure terminal
awplus(config)# no radius-server retransmit
To configure the RADIUS retransmit count globally with 5, use the following
commands:
awplus# configure terminal
awplus(config)# radius-server retransmit 5
To disable retransmission of requests to a RADIUS server, use the following
commands:
awplus# configure terminal
awplus(config)# radius-server retransmit 0
Parameter Description
<retries> RADIUS server retries in the range <0-100>.
The number of times a request is resent to a RADIUS server that
does not respond, before the server is considered dead and the
next server is tried. If no retransmit value is specified for a
particular RADIUS server using the radius-server host
command, this global value is used.

Allied Telesis IE340 Series Specifications

General

Brand	Allied Telesis
Model	IE340 Series
Category	Switch
Language	English