C613-50631-01 Rev A Command Reference for IE340 Series 2888
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
AMF AND AMF PLUS COMMANDS
CLEAR
ATMF RECOVERY-FILE
clear atmf recovery-file
Overview Use this command to delete all of a node’s recovery files. It deletes the recovery
files stored on:
•the local node,
•neighbor nodes, and
• external media (USB or SD card).
Syntax
clear atmf recovery-file
Mode Privileged Exec
Usage notes AMF recovery files are created for nodes with special links. Special links include:
•virtual links,
• area links terminating on an AMF master, and
• area virtual links terminating on an AMF master.
An AMF node with one of these special links pushes its startup configuration to its
neighbors and to any attached external media. It then fetches and applies this
configuration at recovery time. This configuration enables it to contact the AMF
master and initiate a recovery.
Recovery files can become out of date if:
• a node’s neighbor is off line when changes are made to its configuration, or
• when a node no longer contains a special link.
Example To clear a node’s recovery files, use the command:
node1# clear atmf recovery-file
Output Figure 57-3: If AlliedWare Plus detects that a node contains a special link then
the following message is displayed
Related
commands
show atmf recovery-file
Command
changes
Version 5.4.8-0.2: command added
node1#clear atmf recovery-fileď€
% Warning: ATMF recovery files have been removed. ď€
ATMF recovery may fail. Please save running-configuration.
To Next Page
Loading...
Need help?
General
