Allied Telesis IE340 Series - debug ipv6 ospf packet

C613-50631-01 Rev A Command Reference for IE340 Series 1238
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
OSPFV3 FOR IPV6 COMMANDS
DEBUG
IPV6 OSPF PACKET
debug ipv6 ospf packet
Overview This command enables debugging options for IPv6 OSPF packets.
To enable all debugging options, specify debug ipv6 ospf packet with no
additional parameters.
The no and undebug variants of this command disable IPv6 OSPF packet
debugging. Use this command without parameters to disable all options.
Syntax
debug ipv6 ospf packet [dd] [detail] [hello] [ls-ack]
[ls-request] [ls-update] [recv] [send]
no debug ipv6 ospf packet [dd] [detail] [hello] [ls-ack]
[ls-request] [ls-update] [recv] [send]
Mode Privileged Exec and Global Configuration
Examples To enable debugging for hello packets, use the following command:
awplus# debug ipv6 ospf packet hello
Related
commands
terminal monitor
undebug ipv6 ospf packet
Parameter Description
dd Specifies debugging for IPv6 OSPF database descriptions.
detail Sets the debug option to detailed information.
hello Specifies debugging for IPv6 OSPF hello packets.
ls-ack Specifies debugging for IPv6 OSPF link state acknowledgments.
ls-request Specifies debugging for IPv6 OSPF link state requests.
ls-update Specifies debugging for IPv6 OSPF link state updates.
recv Specifies the debug option set for received packets.
send Specifies the debug option set for sent packets.