C613-50631-01 Rev A Command Reference for IE340 Series 2794
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
AMF AND AMF PLUS COMMANDS
ATMF
AREA PASSWORD
atmf area password
Overview This command sets a password on an AMF area.
Use the no variant of this command to remove the password.
This command is only valid on AMF controllers, master nodes and gateway nodes.
The area name must have been configured first.
Syntax
atmf area <area-name> password [8] <password>
no atmf area <area-name> password
Mode Global Configuration
Usage notes You must configure a password on each area that an AMF controller
communicates with, except for the controller’s local area. The areas must already
have been created using the atmf area command.
Enter the password identically on both of:
• the area that locally contains the controller, and
• the remote AMF area masters
The command show running-config atmf will display the encrypted version of
this password. The encryption keys will match between the controller and the
remote AMF master.
If multiple controller and masters exist in an area, they must all have the same area
configuration.
Example To give the AMF area named Auckland a password of “secure#1” use the following
command on the controller:
controller-1(config)# atmf area Auckland password secure#1
and also use the following command on the master node for the Auckland area:
auck-master(config)# atmf area Auckland password secure#1
Parameter Description
<area-name> The AMF area name.
8 This parameter is displayed in show running-config
output to indicate that it is displaying the password in
encrypted form. You should not enter 8 on the CLI
yourself.
<password> The password is between 8 and 32 characters long. It
can include spaces.
To Next Page
Loading...
Need help?
General
