C613-50631-01 Rev A Command Reference for IE340 Series 817
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
POWER OVER ETHERNET COMMANDS
POWER
-INLINE HANP
power-inline hanp
Overview Use this command to enable High Availability Network Power (HANP), also known
as Continuous PoE. Continuous PoE enables the switches to perform actions such
as software upgrades without forcing the Powered Devices to power cycle. This
means, for example, if you are rebooting a switch connected to a PD such as a
camera, Continuous PoE allows the camera to buffer while the switch is rebooted.
You can configure it on a global or per port level. Enabling it globally enables it on
all PoE ports.
Use the no variant of this command to disable Continuous PoE globally or on the
specified ports.
Syntax
power-inline hanp
no power-inline hanp
Default Continuous PoE is disabled globally by default. If you enable it globally, that
enables it on all ports.
Mode User Exec/Privileged Exec or Interface Configuration for a PoE port
Example To enable Continuous PoE on all ports, use the commands:
awplus# configure terminal
awplus(config)# power-inline hanp
To enable Continuous PoE on all ports except port 1.0.5, use the commands:
awplus# configure terminal
awplus(config)# power-inline hanp
awplus(config)# interface port1.0.5
awplus(config-if)# no power-inline hanp
Related
commands
show power-inline
show power-inline interface
show power-inline interface detail
Command
changes
Version 5.4.6-2.1: command added
Version 5.4.7-0.1: added to x930 series products
Version 5.4.8-0.2: added to x550 series products
Version 5.4.8-2.1: added to x220 series products
To Next Page
Loading...
Need help?
General
