C613-50631-01 Rev A Command Reference for IE340 Series 3041
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
DYNAMIC HOST CONFIGURATION PROTOCOL (DHCP) COMMANDS
DOMAIN
-NAME
domain-name
Overview This command adds a domain name to the DHCP address pool you are
configuring. Use this command to specify the domain name that a client should
use when resolving host names using the Domain Name System. This sets the
domain name details using the pre-defined option 15.
Note that if you add a user-defined option 15 using the option command, then you
will override any settings created with this command.
The no variant of this command removes the domain name from the address pool.
Syntax
domain-name <domain-name>
no domain-name
Mode DHCP Configuration
Examples To add the domain name Nerv_Office to DHCP pool P2, use the commands:
awplus# configure terminal
awplus(config)# ip dhcp pool P2
awplus(dhcp-config)# domain-name Nerv_Office
To remove the domain name Nerv_Office from DHCP pool P2, use the commands:
awplus# configure terminal
awplus(config)# ip dhcp pool P2
awplus(dhcp-config)# no domain-name Nerv_Office
Related
commands
default-router
dns-server
option
service dhcp-server
show ip dhcp pool
subnet-mask
Parameter Description
<domain-name> The domain name you wish to assign the DHCP pool. Valid
characters are any printable character. If the name contains
spaces then you must enclose it in “quotation marks”.
To Next Page
Loading...
Need help?
General
