Allied Telesis IE340 Series - Pluggables and Cabling Commands; Introduction

8
C613-50631-01 Rev A Command Reference for IE340 Series 329
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
Pluggables and
Cabling Commands
Introduction
Overview This chapter provides an alphabetical reference of commands used to configure
and monitor Pluggables and Cabling, including:
• Cable Fault Locator for finding faults in copper cabling
• Optical Digital Diagnostic Monitoring (DDM) to help find fiber issues when
links go down
• Active Fiber Monitoring for detecting changes in optical power received over
fiber cables.
For more information, see the Pluggables and Cabling Feature Overview and
Configuration Guide.
Command List •“clear fiber-monitoring interface” on page 330
•“clear test cable-diagnostics tdr” on page 331
•“debug fiber-monitoring” on page 332
•“fiber-monitoring action” on page 334
•“fiber-monitoring baseline” on page 336
•“fiber-monitoring enable” on page 338
•“fiber-monitoring interval” on page 339
•“fiber-monitoring sensitivity” on page 340
•“show system fiber-monitoring” on page 342
•“show system pluggable” on page 345
•“show system pluggable detail” on page 347
•“show system pluggable diagnostics” on page 350
•“show test cable-diagnostics tdr” on page 352
•“test cable-diagnostics tdr interface” on page 353