Allied Telesis IE340 Series - show g8032 profile

C613-50631-01 Rev A Command Reference for IE340 Series 2736
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
G.8032 ETHERNET RING PROTECTION SWITCHING COMMANDS
SHOW
G8032 PROFILE
show g8032 profile
Overview Use this command to show one specific G.8032 profile or all G.8032 profiles, and
the configured information within each profile.
Syntax
show g8032 profile {<erp-profile-name>|default-profile|all}
Mode User Exec and Privileged Exec
Example To show the profile details for a profile named “prof1”, use the following
command:
awplus# show g8032 profile prof1
Output Figure 55-6: Example output from the show g8032 profile command.
Parameter Description
<erp-profile-name> The name of the G.8032 profile that was created by the
user.
default-profile The default name of the G.8032 profile that was created
automatically by the system.
all Using this will show all G.8032 profiles.
awplus#show g8032 profile prof1
Profile : prof1
===========================
Wait-To-Restore : 5 mins
Hold Off Timer : 0 ms
Guard Timer : 500 ms
Wait-To-Block : 5500 ms
Protection Type : Revertive
ERP Inst : blue
Table 4: Parameters in the output from show g8032 profile command.
Parameter Description
Wait-To-Restore The configured value in <1-12> minutes.
Hold Off Timer The configured value but shown instead in milliseconds
which ranges from 0 to 10,000 (10s) in 100 ms increments.
Guard Timer The configured value which ranges from 10 to 2000 in 10
ms increments.