C613-50631-01 Rev A Command Reference for IE340 Series 2165
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
QOS COMMANDS
STORM
-PROTECTION
storm-protection
Overview Use this command to enable policy-based Storm Protection (such as QSP - QoS
Storm Protection). Storm protection is activated as soon as a port is enabled.
However, it will only be functional after storm-rate and storm-window have been
set.
The no variant of this command disables policy-based Storm Protection.
Syntax
storm-protection
no storm-protection
Default By default, storm protection is disabled.
Mode Policy Map Class Configuration
Examples To enable QSP on cmap2 in pmap2, use the following commands:
awplus# configure terminal
awplus(config)# policy-map pmap2
awplus(config-pmap)# class cmap2
awplus(config-pmap-c)# storm-protection
To disable QSP on cmap2 in pmap2, use the following commands:
awplus# policy-map pmap2
awplus(config-pmap)# class cmap2
awplus(config-pmap-c)# no storm-protection
Related
commands
show mls qos interface storm-status
storm-action
storm-downtime
storm-rate
storm-window
To Next Page
Loading...
Need help?
General
