C613-50631-01 Rev A Command Reference for IE340 Series 3048
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
DYNAMIC HOST CONFIGURATION PROTOCOL (DHCP) COMMANDS
IP
DHCP LEASEQUERY ENABLE
ip dhcp leasequery enable
Overview Use this command to enable the DHCP server to respond to DHCPLEASEQUERY
packets. Enabling the DHCP leasequery feature allows a DHCP Relay Agent to
obtain IP address information directly from the DHCP server using
DHCPLEASEQUERY messages.
Use the no variant of this command to disable the support of DHCPLEASEQUERY
packets.
For more information, see the DHCP Feature Overview and Configuration Guide.
Syntax
ip dhcp leasequery enable
no ip dhcp leasequery enable
Default DHCP leasequery support is disabled by default.
Mode Global Configuration
Examples To enable DHCP leasequery support, use the commands:
awplus# configure terminal
awplus(config)# ip dhcp leasequery enable
To disable DHCP leasequery support, use the commands:
awplus# configure terminal
awplus(config)# no ip dhcp leasequery enable
Related
commands
show counter dhcp-server
show ip dhcp server statistics
show ip dhcp server summary
To Next Page
Loading...
Need help?
General
