C613-50631-01 Rev A Command Reference for IE340 Series 1314
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
BGP AND BGP4+ COMMANDS
BGP
AGGREGATE-NEXTHOP-CHECK
bgp aggregate-nexthop-check
Overview This command affects the operation of the summary-only option on the
aggregate-address command.
This command enables a mode whereby the summary-only option will only
suppress the component routes if those component routes all have the same next
hop. If the routes have different next hops, then they will continue to be advertised
to peers even if the summary-only option is configured. By default this is disabled.
The no variant of this command disables this function.
Syntax
bgp aggregate-nexthop-check
no bgp aggregate-nexthop-check
Default Disabled by default.
Mode Global Configuration
Example
awplus# configure terminal
awplus(config)# bgp aggregate-nexthop-check
Command
changes
Added to AlliedWare Plus prior to 5.4.6-1
Version 5.4.7-2.1: BGP support added for x510 and x550 series
Version 5.4.7-2.4: BGP support added for IE300 series
To Next Page
Loading...
Need help?
General
