C613-50631-01 Rev A Command Reference for IE340 Series 3220
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
LLDP COMMANDS
LLDP
HOLDTIME-MULTIPLIER
lldp holdtime-multiplier
Overview This command sets the holdtime multiplier value. The transmit interval is
multiplied by the holdtime multiplier to give the Time To Live (TTL) value that is
advertised to neighbors.
The no variant of this command sets the multiplier back to its default.
Syntax
lldp holdtime-multiplier <2-10>
no lldp holdtime-multiplier
Default The default holdtime multiplier value is 4.
Mode Global Configuration
Usage The Time-To-Live defines the period for which the information advertised to the
neighbor is valid. If the Time-To-Live expires before the neighbor receives another
update of the information, then the neighbor discards the information from its
database.
Examples To set the holdtime multiplier to 2, use the commands:
awplus# configure terminal
awplus(config)# lldp holdtime-multiplier 2
To set the holdtime multiplier back to its default, use the commands:
awplus# configure terminal
awplus(config)# no lldp holdtime-multiplier 2
Related
commands
show lldp
Parameter Description
<2-10> The multiplier factor.
To Next Page
Loading...
Need help?
General
