C613-50631-01 Rev A Command Reference for IE340 Series 1032
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
RIP COMMANDS
FULLUPDATE
(RIP)
fullupdate (RIP)
Overview Use this command to specify which routes RIP should advertise when performing
a triggered update. By default, when a triggered update is sent, RIP will only
advertise those routes that have changed since the last update. When fullupdate
is configured, the device advertises the full RIP route table in outgoing triggered
updates, including routes that have not changed. This enables faster convergence
times, or allows inter-operation with legacy network equipment, but at the
expense of larger update messages.
Use the no variant of this command to disable this feature.
Syntax
fullupdate
no fullupdate
Default By default this feature is disabled.
Mode RIP Router Configuration
Example To enable the fullupdate (RIP) function, use the commands:
awplus# configure terminal
awplus(config)# router rip
awplus(config-router)# fullupdate
To Next Page
Loading...
Need help?
General
