C613-50631-01 Rev A Command Reference for IE340 Series 3454
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
PROFINET COMMANDS
PROFINET
VLAN
profinet vlan
Overview Use this command to set the VLAN number for the PROFINET protocol.
VLAN configuration on your device is optional, but all ports running between
PROFINET devices must belong to the same VLAN using “Access Mode”. Configure
the PROFINET software globally to listen on that VLAN.
Use the no variant of this command to set the PROFINET VLAN to the default.
Syntax
profinet vlan <vlan-id>
no profinet vlan
Default By default, PROFINET is configured on VLAN 1.
Mode Global Configuration
Example To configure PROFINET to use VLAN 2, use the commands:
awplus# configure terminal
awplus(config)# profinet vlan 2
Related
commands
erase factory-default
clear profinet persistent-storage
show profinet status
Command
changes
Version 5.5.2-1.6 and 5.5.3-0.1: command added
Parameter Description
<vlan-id> The ID of the VLAN PROFINET is running on.
To Next Page
Loading...
Need help?
General
