C613-50631-01 Rev A Command Reference for IE340 Series 2272
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
AUTHENTICATION COMMANDS
AUTH
-MAC STATIC
auth-mac static
Overview This command configures MAC authentication to use static entries in the FDB.
Static entries persist in the FDB, even if there is no traffic flow from the supplicant.
When static FDB entries are configured, the auth roaming disconnected command
is supported for MAC authentication. This command allows a supplicant to move
to another authenticating interface without re-authentication.
Use the no variant of this command to revert to dynamic FDB entries.
Syntax
auth-mac static
no auth-mac static
Default By default MAC authentication supplicants are added to the FDB dynamically.
Mode Global Configuration
Example To configure MAC authentication to use static FDB entries, use the following
commands:
awplus# configure terminal
awplus(config)# auth-mac static
To configure MAC authentication to use dynamic FDB entries, use the following
commands:
awplus# configure terminal
awplus(config)# no auth-mac static
Related
commands
auth roaming disconnected
show auth
show dot1x
Command
changes
Version 5.4.7-2.4: Command added
Version 5.4.8-2.1: Command added to AR2050V, AR3050S, AR4050S
To Next Page
Loading...
Need help?
General
