C613-50631-01 Rev A Command Reference for IE340 Series 890
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
IP ADDRESSING AND PROTOCOL COMMANDS
IP
IRDP LIFETIME
ip irdp lifetime
Overview This command sets the maximum length of time that hosts should consider the
Router Discovery advertised addresses as valid router addresses. If you change the
lifetime value, also change the maxadvertisementinterval and the
minadvertisementinterval to maintain the following ratios:
This command is synonymous with the ip irdp hostname<0-9000> command.
The no variant of this command sets the lifetime back to the default of 1800
seconds.
Syntax
ip irdp lifetime <0-9000>
no ip irdp lifetime
Default The lifetime value is 1800 seconds.
Mode Interface Configuration for a VLAN interface or a local loopback interface.
Examples To set the lifetime value to 4000 seconds for addresses advertised on vlan6, use
the following commands:
awplus# configure terminal
awplus(config)# interface vlan6
awplus(config-if)# ip irdp lifetime 4000
To set the lifetime value to the default of 1800 seconds for addresses advertised on
vlan6, use the following commands:
awplus# configure terminal
awplus(config)# interface vlan6
awplus(config-if)# no ip irdp lifetime
Related
commands
ip irdp
ip irdp maxadvertinterval
ip irdp minadvertinterval
show ip irdp interface
Parameter Description
<0-9000> Lifetime value in seconds of the advertised addresses.
To Next Page
Loading...
Need help?
General
