C613-50631-01 Rev A Command Reference for IE340 Series 1754
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
MULTICAST COMMANDS
DEBUG
NSM MCAST6
debug nsm mcast6
Overview Use this command to debug IPv6 events in the Multicast Routing Information Base
(MRIB).
This command is intended for use by Allied Telesis authorized service personnel
for diagnostic purposes.
Syntax
debug nsm mcast6 {all|fib-msg|mrt|register|stats|vif}
no debug nsm mcast6 {all|fib-msg|mrt|register|stats|vif}
Mode Privileged Exec and Global Configuration
Examples To enable debugging of all multicast route events, use the commands:
awplus# configure terminal
awplus(config)# debug nsm mcast6 all
To enable debugging of PIM register entries, use the commands:
awplus# configure terminal
awplus(config)# debug nsm mcast6 register
Parameter Description
all All IPv6 multicast route debugging.
fib-msg Forwarding Information Base (FIB) messages.
mrt Multicast routes.
register Multicast PIM register messages.
stats Multicast statistics.
vif Multicast interfaces.
To Next Page
Loading...
Need help?
General
