Allied Telesis IE340 Series - auth guest-vlan hw-forwarding

C613-50631-01 Rev A Command Reference for IE340 Series 2224
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
AUTHENTICATION COMMANDS
AUTH
GUEST-VLAN HW-FORWARDING
auth guest-vlan hw-forwarding
Overview Use this command to enable hardware forwarding on the guest VLAN. By default,
hardware forwarding is disabled and all traffic on the VLAN is forwarded by the
CPU.
Use the no variant of this command to disable hardware forwarding on the guest
VLAN.
Syntax
auth guest-vlan hw-forwarding
no auth guest-vlan hw-forwarding
Default Disabled.
Mode Interface Configuration for a static channel, a dynamic (LACP) channel group, or a
switch port; or Authentication Profile mode.
Example To enable guest VLAN hardware forwarding on interface port1.0.2, use the
commands:
awplus# configure terminal
awplus(config)# interface port1.0.2
awplus(config-if)# auth guest-vlan hw-forwarding
To disable guest VLAN hardware forwarding on port1.0.2, use the commands:
awplus# configure terminal
awplus(config)# interface port1.0.2
awplus(config-if)# no auth guest-vlan hw-forwarding
To enable guest VLAN hardware forwarding authentication profile 'student', use
the commands:
awplus# configure terminal
awplus(config)# auth profile student
awplus(config-auth-profile)# auth guest-vlan hw-forwarding
Related
commands
auth profile (global)
auth guest-vlan
auth guest-vlan forward
Command
changes
Version 5.5.0-1.1: command added to x230, GS970M, IE210 series switches.
Version 5.5.1-0.1: command added to all other AlliedWare Plus switches.