C613-50631-01 Rev A Command Reference for IE340 Series 1800
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
PIM-SM COMMANDS
IP
PIM CISCO-REGISTER-CHECKSUM GROUP-LIST
ip pim cisco-register-checksum group-list
Overview Use this command to configure the option to calculate the Register checksum over
the whole packet on multicast groups specified by the access-list. This command
is used to inter-operate with older Cisco IOS versions.
Use the no variant of this command to revert to default settings.
Syntax
ip pim cisco-register-checksum group-list <acl>
no ip pim cisco-register-checksum group-list <acl>
Mode Global Configuration
Example
awplus# configure terminal
awplus(config)# ip pim cisco-register-checksum group-list 34
awplus(config)# access-list 34 permit 224.0.1.3
Command
changes
Version 5.4.7-1.1: VRF-lite support added SBx8100.
Version 5.4.8-1.1: VRF-lite support added x930, SBx908 GEN2.
Parameter Description
<acl> The standard, expanded or named ACL to use.
To Next Page
Loading...
Need help?
General
