Allied Telesis IE340 Series - ip rip receive-packet

C613-50631-01 Rev A Command Reference for IE340 Series 1042
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
RIP COMMANDS
IP
RIP RECEIVE-PACKET
ip rip receive-packet
Overview Use this command to configure the interface to enable the reception of RIP
packets.
Use the no variant of this command to disable this feature.
Syntax
ip rip receive-packet
no ip rip receive-packet
Default Enabled
Mode Interface Configuration for a VLAN interface.
Example To turn on packet receiving on the interface vlan2, use the commands:
awplus# configure terminal
awplus(config)# interface vlan2
awplus(config-if)# ip rip receive-packet
Related
commands
ip rip send-packet