C613-50631-01 Rev A Command Reference for IE340 Series 2946
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
AMF AND AMF PLUS COMMANDS
SHOW
ATMF AREA NODES-DETAIL
show atmf area nodes-detail
Overview Use this command to display detailed information about an AMF controller’s
remote nodes.
Note that this command can only be run from a controller node.
Syntax
show atmf area nodes-detail <area-name> [<node-name>]
Mode Privileged Exec
Usage notes If you do not limit the output to a single area or node, this command displays
information about all remote nodes that the controller is aware of. This can be a
very large number of nodes.
Example To show information for all the nodes in area ‘Wellington’, use the command:
controller-1# show atmf area nodes-detail Wellington
The following figure shows partial example output from running this command.
Parameter Description
<area-name> Displays detailed information about nodes in the specified area.
<node-name> Displays detailed information about the specified node.
Table 70: Output from the show atmf area nodes-detail Wellington command
controller-1#show atmf area nodes-detail Wellington
Wellington Area Node Information:
Node name well-gate
Parent node name : well-master
Domain id : well-gate’s domain
Board type : 368
Distance to core : 1
Flags : 50
Extra flags : 0x00000006
MAC Address : 001a.eb56.9020
Node name well-master
Parent node name : none
Domain id : well-master’s domain
Board type : 333
Distance to core : 0
Flags : 51
Extra flags : 0x0000000c
MAC Address : eccd.6d3f.fef7
...
To Next Page
Loading...
Need help?
General
