Allied Telesis IE340 Series - neighbor enforce-multihop

C613-50631-01 Rev A Command Reference for IE340 Series 1445
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
BGP AND BGP4+ COMMANDS
NEIGHBOR
ENFORCE-MULTIHOP
neighbor enforce-multihop
Overview Use this command to enforce the requirement that BGP and BGP4+ neighbors
form multihop connections.
Use the no variant of this command to turn off this feature.
Syntax
neighbor <neighborid> enforce-multihop
no neighbor <neighborid> enforce-multihop
Mode [BGP] Router Configuration or IPv4 Address Family Configuration
Mode [BGP4+] Router Configuration
Parameter Description
<neighborid> {<ip-address>|<ipv6-addr>|<peer-group>}
<ip-address> The address of an IPv4 BGP neighbor, in dotted
decimal notation A.B.C.D.
<ipv6-addr> The address of an IPv6 BGP4+ neighbor, entered
in hexadecimal in the format X:X::X:X.
<peer-group> Name of an existing peer-group. For
information on how to create peer groups, refer
to the neighbor peer-group (add a neighbor)
command, and neighbor route-map command.
When this parameter is used with this
command, the command applies on all peers in
the specified group.