37
C613-50631-01 Rev A Command Reference for IE340 Series 1906
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
PIM-DM Commands
Introduction
Overview This chapter provides an alphabetical reference of PIM-DM commands. For
commands common to PIM-SM and PIM-DM, see Multicast Commands.
Command List •“debug pim dense-mode all” on page 1908
•“debug pim dense-mode context” on page 1909
•“debug pim dense-mode decode” on page 1910
•“debug pim dense-mode encode” on page 1911
•“debug pim dense-mode fsm” on page 1912
•“debug pim dense-mode mrt” on page 1913
•“debug pim dense-mode nexthop” on page 1914
•“debug pim dense-mode nsm” on page 1915
•“debug pim dense-mode vif” on page 1916
•“ip pim dense-mode” on page 1917
•“ip pim dense-mode passive” on page 1918
•“ip pim dense-mode wrong-vif-suppression” on page 1919
•“ip pim ext-srcs-directly-connected” on page 1920
•“ip pim hello-holdtime (PIM-DM)” on page 1921
•“ip pim hello-interval (PIM-DM)” on page 1922
•“ip pim max-graft-retries” on page 1923
•“ip pim neighbor-filter (PIM-DM)” on page 1925
•“ip pim propagation-delay” on page 1926
•“ip pim state-refresh origination-interval” on page 1927
•“service pdm” on page 1928
To Next Page
Loading...
Need help?
General
