Allied Telesis IE340 Series - snmp-server view

C613-50631-01 Rev A Command Reference for IE340 Series 3211
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
SNMP COMMANDS
SNMP
-SERVER VIEW
snmp-server view
Overview Use this command to create an SNMP view that specifies a sub-tree of the MIB.
Further sub-trees can then be added by specifying a new OID to an existing view.
Views can be used in SNMP communities or groups to control the remote
manager’s access.
NOTE: The object identifier must be specified in a sequence of integers separated by
decimal points.
The no variant of this command removes the specified view on the device. The
view must already exist.
Syntax
snmp-server view <view-name> <mib-name> {included|excluded}
no snmp-server view <view-name>
Mode Global Configuration
Examples The following command creates a view called “loc” that includes the system
location MIB sub-tree.
awplus(config)# snmp-server view loc 1.3.6.1.2.1.1.6.0 included
To remove the view “loc” use the following command
awplus(config)# no snmp-server view loc
Related
commands
show snmp-server view
snmp-server community
Parameter Description
<view-name> SNMP server view name.
The view name is a string up to 20 characters long and is case
sensitive.
<mib-name> Object identifier of the MIB.
included Include this OID in the view.
excluded Exclude this OID in the view.