Allied Telesis IE340 Series - show interface switchport vlan translation

C613-50631-01 Rev A Command Reference for IE340 Series 647
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
VLAN COMMANDS
SHOW
INTERFACE SWITCHPORT VLAN TRANSLATION
show interface switchport vlan translation
Overview Use this command to display VLAN translation information for some or all
interfaces.
Syntax
show interface switchport vlan translation [interface <int>]
Mode User Exec and Privileged Exec
Example To display VLAN translation information for port1.0.1, use the command:
awplus# show interface switchport vlan translation interface
port1.0.1
Output Figure 16-2: Example output from show interface switchport vlan translation
interface port1.0.1
Output Figure 16-3: Example output from show interface switchport vlan translation
Parameter Description
interface <int> The interface to display information about. An interface can
be a switch port (e.g. port1.0.4), a static channel group (e.g.
sa2) or a dynamic (LACP) channel group (e.g. po2).
awplus#show interface switchport vlan translation interface
port1.0.1

VLAN on Wire VLAN Outer Vlan 
================= ================= =================
200 100 300
default accept
awplus#show interface switchport vlan translation

Interface: port1.0.1
VLAN on Wire VLAN Outer Vlan
================= ================= =================
200 100 300
default accept

Interface: port1.0.2
VLAN on Wire VLAN Outer Vlan
================= ================= =================
69 1
default accept