Allied Telesis IE340 Series - lacp system-priority

C613-50631-01 Rev A Command Reference for IE340 Series 792
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
LINK AGGREGATION COMMANDS
LACP
SYSTEM-PRIORITY
lacp system-priority
Overview Use this command to set the system priority of a local system. This is used in
determining the system responsible for resolving conflicts in the choice of
aggregation groups.
Use the no variant of this command to reset the system priority of the local system
to the default.
Syntax
lacp system-priority <1-65535>
no lacp system-priority
Default The default is 32768.
Mode Global Configuration
Example
awplus# configure terminal
awplus(config)# lacp system-priority 6700
Parameter Description
<1-65535> LACP system priority. Lower numerical values have higher priorities.