21
C613-50631-01 Rev A Command Reference for IE340 Series 838
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
GVRP Commands
Introduction
Overview With Generic VLAN Registration Protocol (GVRP) enabled, the switch can exchange
VLAN configuration information with other GVRP enabled switches. VLANs can be
dynamically created and managed through trunk ports.
• There is a limit of 400 VLANs supported by the AlliedWare Plus GVRP
implementation. VLANs may be numbered 1-4094, but a limit of 400 of these
VLANs are supported.
• MSTP is not supported by the AlliedWare Plus GVRP implementation. GVRP
and MSTP are mutually exclusive. STP and RSTP are supported by GVRP.
This chapter provides an alphabetical reference for commands used to configure
GVRP. For information about GVRP, including configuration, see the GVRP Feature
Overview and Configuration Guide.
Command List •“clear gvrp statistics” on page 839
•“debug gvrp” on page 840
•“gvrp (interface)” on page 842
•“gvrp dynamic-vlan-creation” on page 843
•“gvrp enable (global)” on page 844
•“gvrp registration” on page 845
•“gvrp timer” on page 846
•“show debugging gvrp” on page 848
•“show gvrp configuration” on page 849
•“show gvrp machine” on page 850
•“show gvrp statistics” on page 851
•“show gvrp timer” on page 852
To Next Page
Loading...
Need help?
General
