C613-50631-01 Rev A Command Reference for IE340 Series 1200
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
OSPF COMMANDS
SHOW
IP PROTOCOLS OSPF
show ip protocols ospf
Overview Use this command to display OSPF process parameters and statistics.
For information on filtering and saving command output, see the “Getting Started
with AlliedWare Plus” Feature Overview and Configuration Guide.
Syntax
show ip protocols ospf
Mode User Exec and Privileged Exec
Examples To display OSPF process parameters and statistics, use the command:
awplus# show ip protocols ospf
Output Figure 28-23: Example output from the show ip protocols ospf command
Routing Protocol is "ospf 200"
Invalid after 0 seconds, hold down 0, flushed after 0
Outgoing update filter list for all interfaces is
Redistributed kernel filtered by filter1
Incoming update filter list for all interfaces is
Redistributing: kernel
Routing for Networks:
192.30.30.0/24
192.40.40.0/24
Routing Information Sources:
Gateway Distance Last Update
Distance: (default is 110)
Address Mask Distance List
To Next Page
Loading...
