C613-50631-01 Rev A Command Reference for IE340 Series 3082
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
DYNAMIC HOST CONFIGURATION PROTOCOL (DHCP) COMMANDS
RANGE
range
Overview This command adds an address range to the DHCP address pool you are
configuring. The DHCP server responds to client requests received from the pool’s
network. It assigns an IP addresses within the specified range. The IP address range
must lie within the network. You can add multiple address ranges and individual IP
addresses for a DHCP pool by using this command multiple times.
The no variant of this command removes an address range from the DHCP pool.
Use the no range all command to remove all address ranges from the DHCP pool.
Syntax
range <ip-address> [<ip-address>]
no range <ip-address> [<ip-address>]
no range all
Mode DHCP Configuration
Examples To add an address range of 192.0.2.5 to 192.0.2.16 to the pool Nerv_Office, use the
command:
awplus# configure terminal
awplus(config)# ip dhcp pool Nerv_Office
awplus(dhcp-config)# range 192.0.2.5 192.0.2.16
To add the individual IP address 192.0.2.2 to a pool, use the command:
awplus(dhcp-config)# range 192.0.2.2
To remove all address ranges from a pool, use the command:
awplus(dhcp-config)# no range all
Related
commands
ip dhcp pool
service dhcp-server
show ip dhcp pool
Parameter Description
<ip-address> IPv4 address range for DHCP clients, in dotted decimal
notation. The first IP address is the low end of the range, the
second IP address is the high end. Specify only one IP address
to add an individual IP address to the address pool.
To Next Page
Loading...
Need help?
General
