C613-50631-01 Rev A Command Reference for IE340 Series 656
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
VLAN COMMANDS
SHOW
VLAN FILTER
show vlan filter
Overview Use this command to display information about the configured VLAN filters. VLAN
filters apply access-maps (and therefore ACLs) to VLANs. This enables you to filter
traffic ingressing specified VLANs.
Syntax
show vlan filter [<access-map-name>]
Mode User Exec/Privileged Exec
Example To display information about the filter that uses the access-map named “deny_all”,
use the command:
awplus# show vlan filter deny_all
Output Figure 16-11: Example output from show vlan filter
Related
commands
vlan access-map
vlan filter
Command
changes
Version 5.4.6-2.1: command added
Parameter Description
<access-map-name> The name of an access-map. The command output displays
only the filters that use that access-map.
awplus#show vlan filter deny_all
Vlan filter : deny_all
direction : ingress
vlan list : 48-49
access map : deny_all
Hardware MAC access list 4000
10 deny any any
To Next Page
Loading...
