C613-50631-01 Rev A Command Reference for IE340 Series 3384
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
TRIGGER COMMANDS
TRIGGER
trigger
Overview This command is used to access the Trigger Configuration mode for the specified
trigger. Once Trigger Configuration mode has been entered the trigger type
information can be configured and the trigger scripts and other operational
parameters can be specified. At a minimum the trigger type information must be
specified before the trigger can become active.
The no variant of this command removes a specified trigger and all configuration
associated with it.
Syntax
trigger <1-250>
no trigger <1-250>
Mode Global Configuration
Examples To enter trigger configuration mode for trigger 12, use the commands:
awplus# configure terminal
awplus(config)# trigger 12
To completely remove all configuration associated with trigger 12, use the
commands:
awplus# configure terminal
awplus(config)# no trigger 12
Related
commands
show trigger
trigger activate
Parameter Description
<1-250> A trigger ID.
To Next Page
Loading...
Need help?
General
