C613-50631-01 Rev A Command Reference for IE340 Series 1125
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
OSPF COMMANDS
DEBUG
OSPF LSA
debug ospf lsa
Overview This command enables debugging options for OSPF Link State Advertisements
(LSA) troubleshooting. This displays information related to internal operations of
LSAs.
To enable all debugging options, specify debug ospf lsa with no additional
parameters.
The no and undebug variant of this command disable OSPF LSA debugging. Use
this command without parameters to disable all the options.
Syntax
debug ospf lsa [flooding] [generate] [install] [maxage]
[refresh]
no debug ospf lsa [flooding] [generate] [install] [maxage]
[refresh]
Mode Privileged Exec and Global Configuration
Examples
awplus# undebug ospf lsa refresh
Output Figure 28-1: Example output from the debug ospf lsa command
Related
commands
terminal monitor
undebug ospf lsa
Parameter Description
flooding Displays LSA flooding.
generate Displays LSA generation.
install Show LSA installation.
maxage Shows maximum age of the LSA in seconds.
refresh Displays LSA refresh.
2002/05/09 14:08:11 OSPF: LSA[10.10.10.10:10.10.10.70]: instance(0x8139cd0) ď€
created with Link State Updateď€
2002/05/09 14:08:11 OSPF: RECV[LS-Upd]: From 10.10.10.70 via vlan5:10.10.10.50 ď€
(10.10.10.10 -> 224.0.0.5)ď€
2002/05/09 14:12:33 OSPF: SEND[LS-Upd]: Begin send queueď€
2002/05/09 14:12:33 OSPF: SEND[LS-Upd]: # of LSAs 1, destination 224.0.0.5ď€
2002/05/09 14:12:33 OSPF: SEND[LS-Upd]: End send queueď€
2002/05/09 14:12:33 OSPF: SEND[LS-Upd]: To 224.0.0.5 via vlan5:10.10.10.50ď€
To Next Page
Loading...
Need help?
General
