Allied Telesis IE340 Series - debug alarm

C613-50631-01 Rev A Command Reference for IE340 Series 554
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
ALARM MONITORING COMMANDS
DEBUG
ALARM
debug alarm
Overview Use this command to enable debugging of the Alarm Monitoring feature. When
debugging is enabled, the switch displays debugging messages on the terminal
monitor and in the log.
Use the no variant of this command to disable debugging of the Alarm Monitoring
feature.
Syntax
debug alarm
no debug alarm
Default Disabled
Mode Global Configuration
Example To turn on Alarm debugging, use the commands:
awplus# configure terminal
awplus(config)# debug alarm
Related
commands
show debugging alarm