C613-50631-01 Rev A Command Reference for IE340 Series 3192
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
SNMP COMMANDS
SNMP
-SERVER COMMUNITY
snmp-server community
Overview This command creates an SNMP community, optionally setting the access mode
for the community. The default access mode is read-only. If view is not specified,
the community allows access to all the MIB objects. The SNMP communities are
only valid for SNMPv1 and v2c and provide very limited security. Communities
should not be used when operating SNMPv3.
The no variant of this command removes an SNMP community. The specified
community must already exist on the device.
Syntax
snmp-server community <community-name> {view
<view-name>|ro|rw|<access-list>}
no snmp-server community <community-name>
Mode Global Configuration
Example Use the following commands to create an SNMP community called ‘public’ with
read-only access to all MIB variables from any management station:
awplus# configure terminal
awplus(config)# snmp-server community public ro
Use the following commands to remove an SNMP community called ‘public’
awplus# configure terminal
awplus(config)# no snmp-server community public
Related
commands
show snmp-server
show snmp-server community
snmp-server view
Parameter Description
<community-name> Community name. The community name is a case sensitive
string of up to 20 characters.
view Configure SNMP view. If view is not specified, the community
allows access to all the MIB objects.
<view-name> View name. The view name is a string up to 20 characters long
and is case sensitive.
ro Read-only community.
rw Read-write community.
<access-list> <1-99> Access list number.
To Next Page
Loading...
Need help?
General
