C613-50631-01 Rev A Command Reference for IE340 Series 1165
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
OSPF COMMANDS
OVERFLOW
DATABASE
overflow database
Overview Use this command to limit the maximum number of Link State Advertisements
(LSAs) that can be supported by the current OSPF instance.
Use the no variant of this command to have no limit on the maximum number of
LSAs.
Syntax
overflow database <0-4294967294> {hard|soft}
no overflow database
Mode Router Configuration
Usage Use hard with this command if a shutdown is required if the number of LSAs
exceeds the specified number. Use soft with this command if a shutdown is not
required, but a warning message is required, if the number of LSAs exceeds the
specified number.
Example The following example shows setting the database overflow to 500, and a
shutdown to occur, if the number of LSAs exceeds 500.
awplus# configure terminal
awplus(config)# router ospf 100
awplus(config-router)# overflow database 500 hard
Parameter Description
<0-4294967294> The maximum number of LSAs.
hard Shutdown occurs if the number of LSAs exceeds the specified
value.
soft Warning message appears if the number of LSAs exceeds the
specified value.
To Next Page
Loading...
Need help?
General
