C613-50631-01 Rev A Command Reference for IE340 Series 2853
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
AMF AND AMF PLUS COMMANDS
ATMF
RECOVER OVER-ETH
atmf recover over-eth
Overview Use this command to enable AMF recovery over an AR-series device’s Eth port. This
setting persists even after restoring a device to a ‘clean’ state with the erase
factory-default or atmf cleanup command.
Use the no variant of this command to disable AMF recover over an Eth port.
Syntax
atmf recover over-eth
no atmf recover over-eth
Default Eth ports cannot be used for recovery.
Mode Privileged Exec
Usage notes AMF links over Eth ports are only available if your network is running in AMF secure
mode (see atmf secure-mode for more information on AMF secure mode).
Example To enable AMF recovery over an Eth port, use the command:
awplus# atmf recover over-eth
To disable AMF recovery over an Eth port, use the commands:
awplus# no atmf recover over-eth
Related
commands
atmf-link
atmf recover
atmf secure-mode
erase factory-default
show atmf detail
Command
changes
Version 5.5.0-1.1: command added
To Next Page
Loading...
Need help?
General
