C613-50631-01 Rev A Command Reference for IE340 Series 2905
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
AMF AND AMF PLUS COMMANDS
DELETE
(AMF-PROVISION)
delete (amf-provision)
Overview This command deletes files that have been created for loading onto a provisioned
node. It can only be run on master nodes.
Syntax
delete
Mode AMF Provisioning
Usage notes This command is only available on master nodes in the AMF network. The
command will only work if the provisioned node specified in the command has
already been set up (although the device itself is still yet to be installed). Otherwise,
an error message is shown when the command is run.
You may want to use the delete command to delete a provisioned node that was
created in error or that is no longer needed.
This command cannot be used to delete backups created by the AMF backup
procedure. In this case, use the command atmf backup delete to delete the files.
NOTE: This command allows provisioned entries to be deleted even if they have been
referenced by the atmf provision (interface) command, so take care to only delete
unwanted entries.
Example To delete backup files for a provisioned node named device3 use the command:
device1# atmf provision node device3
device1(atmf-provision)# delete
To confirm that the backup files for provisioned node device3 have been deleted
use the command:
device1# show atmf backup
The output should show that the provisioned node device3 no longer exists in the
backup file, as shown in the figure below:
To Next Page
Loading...
Need help?
General
