C613-50631-01 Rev A Command Reference for IE340 Series 1416
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
BGP AND BGP4+ COMMANDS
NEIGHBOR
CAPABILITY GRACEFUL-RESTART
neighbor capability graceful-restart
Overview Use this command to configure the device to advertise the Graceful Restart
Capability to BGP and BGP4+ neighbors.
Use the no variant of this command to configure the device so it does not advertise
the Graceful Restart Capability to its neighbor.
Syntax
neighbor <neighborid> capability graceful-restart
no neighbor <neighborid> capability graceful-restart
Default Disabled
Mode [BGP] Router Configuration or IPv4 Address Family Configuration
Mode [BGP4+] IPv6 Address Family Configuration
Usage Use the neighbor capability graceful-restart command to advertise to the BGP
or BGP4+ neighbor routers the capability of graceful restart. First specify the BGP
or BGP4+ neighbor’s remote-as identification number as assigned by the
neighbor router.
The graceful restart capability is advertised only when the graceful restart
capability has been enabled using the bgp graceful-restart command.
Parameter Description
<neighborid> {<ip-address>|<ipv6-addr>|<peer-group>}
<ip-address> Specify the address of an IPv4 BGP neighbor, in
dotted decimal notation A.B.C.D.
<ipv6-addr> Specify the address of an IPv6 BGP4+ neighbor,
entered in hexadecimal in the format X:X::X:X.
<peer-group> Enter the name of an existing peer-group. For
information on how to create peer groups, refer
to the neighbor peer-group (add a neighbor)
command, and neighbor route-map command.
When this parameter is used with this
command, the command applies on all peers in
the specified group.
To Next Page
Loading...
Need help?
General
