Allied Telesis IE340 Series - clear port-security intrusion

C613-50631-01 Rev A Command Reference for IE340 Series 569
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
SWITCHING COMMANDS
CLEAR
PORT-SECURITY INTRUSION
clear port-security intrusion
Overview Use this command to clear the history of the port-security intrusion list on all ports,
or an individual port. If you do not specify a port, this command clears the intrusion
lists of all ports.
This command does not clear any MAC addresses the switch has already learned.
If you want to clear already-learned MAC addresses from the filtering database, use
the clear mac address-table dynamic command or the clear mac address-table
static command.
Syntax
clear port-security intrusion [interface <port>]
Mode Privileged Exec
Examples To see the intrusion list on port1.0.2, use the following command:
awplus# show port-security intrusion interface port1.0.2
To clear the history of port-security intrusion list on port1.0.2, use the following
command:
awplus# clear port-security intrusion interface port1.0.2
To see the port-security status on port1.0.2, use the following command:
awplus# show port-security interface port1.0.2
Parameter Description
<port> Specify the switch port from which the history of violated address
entries will be cleared, e.g. port1.0.4.
Table 15-1: Example output from show port-security intrusion

awplus#show port-security intrusion interface port1.0.2
Port Security Intrusion List
------------------------------------------------------------
Interface: port1.0.2 - 1 intrusion(s) detected
801f.0200.19da