C613-50631-01 Rev A Command Reference for IE340 Series 782
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
UNIDIRECTIONAL LINK DETECTION (UDLD) COMMANDS
UDLD
TIME MESSAGE-INTERVAL
udld time message-interval
Overview Use this command to set the UDLD message send interval on all interfaces.
This is the time, in seconds, between UDLD probe messages.
Use the no variant of this command to reset the message send interval to 15
seconds.
Syntax
udld time message-interval <seconds>
no udld time message-interval
Default The default message send interval is 15 seconds.
Mode Global Configuration
Example To change UDLD message sending interval to 30 sec on all interfaces, use the
commands:
awplus# configure terminal
awplus(config)# udld time message-interval 30
To reset the message sending interval to 15 seconds, use the commands:
awplus# configure terminal
awplus(config)# no udld time message-interval
Related
commands
udld enable
udld port
show udld
Parameter Description
<seconds> 7-90ď€
Specify the message send interval in seconds.
To Next Page
Loading...
Need help?
General
