Allied Telesis IE340 Series - show udld neighbors

C613-50631-01 Rev A Command Reference for IE340 Series 773
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
UNIDIRECTIONAL LINK DETECTION (UDLD) COMMANDS
SHOW
UDLD NEIGHBORS
show udld neighbors
Overview Use this command to display UDLD neighbor status.
Syntax
show udld neighbors [<interface-name>] [detail]
Mode Privileged Exec
Example To show UDLD information for all neighbors, use the command:
awplus# show udld neighbors
To show detailed UDLD neighbor information for port1.0.1, use the command:
awplus# show udld neighbours port1.0.1 detail
Output Figure 18-3: Example output from show udld neighbors
Figure 18-4: Example output from show udld neighbor port1.0.1 detail
Related
commands
udld port
udld port disable
udld enable
Parameter Description
<interface-name> Show UDLD neighbor information for a specified interface.
detail This option provides a greater level of detail.
awplus#show udld neighbors
Port Device-ID Port-ID Device-Name Neighbor-State
----------- ------------ ------------ ------------- --------------
port1.0.1 0000F4272DA2 port2.0.1 X930 Bidirectional
port1.0.2 0000F5572632 port1.0.15 X610 Bidirectional
awplus# show udld neighbor port1.0.1 detail
[port1.0.1]
Device-ID : 0000F4272DA2
Port-ID : port2.0.1
Device-Name : X930
Operational-State: Bidirectional
Expiration-time : 35 seconds
Message-Interval : 15 seconds
Timeout-Interval : 5 seconds

Neighbors in Echo:
Device-ID Port-ID 
------------ ------------ 
0000F4272DA2 port2.0.1 
0000F5572632 port1.0.15