Allied Telesis IE340 Series - show storm-control

C613-50631-01 Rev A Command Reference for IE340 Series 616
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
SWITCHING COMMANDS
SHOW
STORM-CONTROL
show storm-control
Overview Use this command to display storm-control information for all interfaces or a
particular interface.
Syntax
show storm-control [<port>]
Mode User Exec and Privileged Exec
Example To display storm-control information for port1.0.2, use the following command:
awplus# show storm-control port1.0.2
Output Figure 15-12: Example output from the show storm-control command for
port1.0.2
Related
commands
storm-control level
Parameter Description
<port> The port to display information about. The port may be:
• a switchport (e.g. port1.0.4)
• a static channel group (e.g. sa2)
• a dynamic (LACP) channel group (e.g. po2)
Port BcastLevel McastLevel DlfLevel
port1.0.2 40. 0% 100. 0% 100. 0%