C613-50631-01 Rev A Command Reference for IE340 Series 1131
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
OSPF COMMANDS
DEFAULT
-METRIC (OSPF)
default-metric (OSPF)
Overview This command sets default metric values for the OSPF routing protocol.
The no variant of this command returns OSPF to using built-in, automatic metric
translations, as appropriate for each routing protocol.
Syntax
default-metric <1-16777214>
no default-metric [<1-16777214>]
Mode Router Configuration
Usage notes A default metric facilitates redistributing routes even with incompatible metrics. If
the metrics do not convert, the default metric provides an alternative and enables
the redistribution to continue. The effect of this command is that OSPF will use the
same metric value for all redistributed routes. Use this command in conjunction
with the redistribute (OSPF) command.
Examples
awplus# configure terminal
awplus(config)# router ospf 100
awplus(config-router)# default-metric 100
awplus# configure terminal
awplus(config)# router ospf 100
awplus(config-router)# no default-metric
Related
commands
redistribute (OSPF)
Parameter Description
<1-16777214> Default metric value appropriate for the specified routing protocol.
To Next Page
Loading...
Need help?
General
