Allied Telesis IE340 Series User Manual

C613-50631-01 Rev A Command Reference for IE340 Series 2654
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
VRRP COMMANDS
SHOW
VRRP COUNTERS
show vrrp counters
Overview This command displays VRRP SNMP counters on the console, as described in the
VRRP MIB and RFC2787, for debugging use while you configure VRRP with
commands in this chapter.
For information on filtering and saving command output, see the “Getting Started
with AlliedWare Plus” Feature Overview and Configuration Guide.
Syntax
show vrrp counters
Mode User Exec and Privileged Exec
Usage notes The output has a section for global counters and a section of counters for each
VRRP instance configured. See the descriptions of the counters below the sample
output as per RFC2787.
NOTE: Note that the counters displayed with this commands are the same counters as
described in RFC 2787, except for the “Monitored Circuit Up” and “Monitored Circuit
Down” counters, which are additions beyond the MIB.
Example To display information about VRRP SNMP counters on the console, enter the
command:
awplus# show vrrp counters
Figure 53-5: Example output from the show vrrp counters command

awplus#show vrrp counters
VRRP Global Counters:
Checksum Errors .... 230
Version Errors ..... 0
VRID Errors ........ 230
VRRP IPv4 counters for VR 10/vlan10:
Master Transitions ........ 0
Received Advertisements ... 0
Internal Errors ........... 0
TTL Errors ................ 0
Received Priority 0 Pkt ... 0
Sent Priority 0 Pkt ....... 0
Received Invalid Type ..... 0
Address List Errors ....... 0
Packet Length Errors ...... 0
Monitored Circuit Up ...... 0
Monitored Circuit Down..... 0

Allied Telesis IE340 Series Specifications

General

Brand	Allied Telesis
Model	IE340 Series
Category	Switch
Language	English