Allied Telesis IE340 Series User Manual

C613-50631-01 Rev A Command Reference for IE340 Series 617
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
SWITCHING COMMANDS
SPEED
speed
Overview This command changes the speed of the specified port. You can optionally specify
the speed or speeds that get autonegotiated, so autonegotiation is only
attempted at the specified speeds.
To see the currently-negotiated speed for ports whose links are up, use the show
interface command. To see the configured speed (when different from the
default), use the show running-config command.
Depending on your switch model and the SFP or SFP+ modules you use, a subset
of the following speed options will be available.
Syntax
speed {10|100|1000|2500|5000|10000|40000|100000}
speed auto [10] [100] [1000] [2500] [5000] [10000] [40000]
[100000]
The following table shows the speed options for each type of port, depending on
the model.
Port type Speed Options (units are Mbps)
RJ.5 copper ports auto (default)
10
100
1000
RJ-45 copper ports auto (default)
10
100
1000
2500
5000
10000
tri-speed copper SFPs auto (default)
10
100
1000
100 Mbps fiber SFPs 100
1000 Mbps fiber SFPs auto (default)
1000
1000 Mbps copper SFPs auto (default)
1000
1000 Mbps fiber CSFPs (Compact SFPs) auto (default)
1000
Multi-speed copper SFP+ auto (default)
1000
2500
5000
10000

Allied Telesis IE340 Series Specifications

General

Brand	Allied Telesis
Model	IE340 Series
Category	Switch
Language	English